- Click on Start.
- Point to Settings,
then over to Control Panel.
- Click on Internet
Options, then the Connection tab.
- Click on Setup.
This will start the Internet Connection Wizard.
- Select "I
have an existing Internet account through my phone line or
local area network (LAN). Click on Next.
- Select "Select
this option if you are accessing the internet using an Internet
service provider or a local area network (LAN)." Click on Next.
- Select "Connect
using my phone line." Click on Next.
- Select "Create
a new dial-up connection." Click on Next.
- In the Telephone
Number field, enter 503 374-1017 or 503 354-1038 if dialing from the Tillamook
area.
Otherwise, enter 503 483-0038 if dialing from South Tillamook
County.(check for other numbers on our Access Numbers page. Uncheck "Dial using the area code and
country code" unless you will be connecting to the Portland
number. Click on Next.
- In the User
Name field, enter the User ID (AND the @oregoncoast.com )you selected when establishing your
account.
ie: user@oregoncoast.com
In the Password field, enter the password you selected
for your account. Note: When the password is entered, it will display
in asterisks (*) for security reasons. Click on Next.
- Select "No" on
the Advanced Settings screen. Click on Next.
- Enter "The Wave!" in
the Connection Name field. Click on Next.
- Select "Yes" on
the Set Up Your Internet Mail Account screen. Click on Next.
- Select "Create
a new Internet mail account." Click on Next.
- Enter your name
in the Display Name field. Click on Next.
- Enter your e-mail
address in the E-mail address field (johnsmith@oregoncoast.com)
- Outgoing mail
server's name: out.oregoncoast.com (POP3 ) server The Incoming
mail server's name is: in.oregoncoast.com Click on Next.
- Enter your
User ID in the POP account name field. Enter your password in the
Password field. Click on Next.
- Enter a friendly
name in the Internet mail account name field, anything you wish,
or leave it at the default of in.oregoncoast.com This is only a
friendly name, not a configuration name. Click on Next.
- Click on Finish!
You're done!
|
